Panasonic BL-C30 - Manual (Page 8)

Installation/Troubleshooting
8
1.2 Camera Feature Locations
1.2.1 Front View
Privacy Button
To temporarily deactivate the camera, press the privacy button. Once pressed, the
button changes from green to red. The video will be temporarily turned off, camera
features become unresponsive and the viewed image turns to a gray screen. To
return to normal operation, press the privacy button again. It should turn green
within a few seconds. To restore video, click [Refresh] on the web browser. Privacy
mode can also be controlled from mobile phones or PCs (see page 26 or page 81
of the Operating Instructions on the Setup CD-ROM).
Indicator Display
Antenna
Pan/Tilt Part
Do not apply pressure to the pan/tilt portion of the
camera. Any forced movement can damage the internal
mechanism.
Indicator/Privacy Button
Pyroelectric Infrared Sensor (see Getting Started)
Power
on
Normal Operation* 1
* 1 The indicator turns orange if the camera is not connected to the LAN.
* 2 The indicator blinks orange if the camera is not connected to the LAN.
Updating Firmware
Getting IP address* 2
Got IP address
Setting
Finished setting
Not on the LAN Orange Orange blinking
Orange blinking
(The camera restarts about 1 minute later.)
Pressing FACTORY
DEFAULT RESET button
Orange blinking Turning off
UPnP TM Failure* 3 Orange blinking (About a 2-second interval)
On the LAN
Using
DHCP
Automatic
Setup
In Privacy Mode Red
Internal Failure Red blinking
Orange Green
Green
Green
Green
Orange and green blinking
Green blinking
Green blinking
* 3 When the sensor is active, the interval between blinks may increase.
Orange blinking