Porter-Cable AZ1203 - Manual (Page 15)

TROUBLESHOOTING
15
Problem Possible cause Solution
No sound, VOLUME is not adjusted. Adjust volume.
no power
Headphone is connected. Disconnect headphone.
Mains cable is not securely connected. Connect mains cable properly.
Batteries are flat. Insert fresh batteries.
Batteries are inserted incorrectly. Insert batteries correctly.
Trying to change over from mains to Remove the mains plug from the
battery supply without removing the plug. unit’s AC MAINS inlet.
No reaction to Electrostatic discharge. Disconnect the set from power supply,
operation of any keys reconnect after a few seconds.
Poor radio reception Weak radio signal. Direct the antenna for optimum
reception.
Interference caused by vicinity of electrical Keep the radio away from electrical
equipment like TVs, computers, engines, etc.. equipment.
no dISC or The CD is badly scratched or dirty. Replace or clean the CD.
Cd Err indication No CD is inserted.
Insert a CD.
The CD is inserted upside down. Insert CD with label upwards.
The laser lens is steamed up. Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty. Replace or clean the CD.
SHUFFLE or PROGRAM is active. Switch off SHUFFLE or PROGRAM play.
Poor cassette Dust and dirt on the heads, capstans or Clean heads, capstans, and pressure
sound quality pressure rollers. rollers.
Use of unsuitable cassette types Only use NORMAL type cassettes for
(METAL or CHROME) for recording. recording.
Recording does Cassette tab(s) may be snapped off. Apply a piece of adhesive tape over
not work the aperture.
Remote control does Batteries are inserted incorrectly. Insert batteries correctly.
not function properly Batteries are flat.
Insert fresh batteries.
(AZ 1208, AZ 1210 only)
Distance to the set is too large. Reduce distance.
English
WARNING
Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.