Porter-Cable AZ1203 - Manual (Page 7)

BASIC FUNCTIONS
7
English
Set the POWER slider to the desired sound source:
CD, TUNER, or TAPE.
The set is switched off when the POWER slider is in position
O OFFFF /TAPE and the keys of the tape deck are released.
Note: If you run the set on batteries, always be sure to switch the
set off after use. This will avoid unnecessary power
consumption.
Adjust the volume using the VOLUME control.
™ Display indication: Volume level from 0 to 32
(AZ 1208, AZ1210 only).
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasised if you place the set against
a wall or shelf. Do not cover any vents and leave sufficient room
around the unit for ventilation.
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For MW and LW stations, direct the built-in antenna by turning the
whole set. The telescopic antenna is not needed.
Improving radio reception
VOLUME
DYNAMIC BASS BOOST
DBB
TUNER
TAPE
CD
VOLUME
DYNAMIC BASS BOOST
DBB
TUNER
TAPE
CD
AZ 1203 AZ 1208
AZ 1210
Adjusting volume and sound
CD SYNCHR
O STAR
T REC O
VOLUME
DYNAMIC
BASS BOOST
DBB
TUNER
TAPE
CD
Switching on and off