Proxima ASA Proxima PROAV9350 - Manual (Page 13)

13
CONNECTING THE PROJECTOR
Connect an external audio
amplifier to these jacks.
(Refer to P14, 15.)
AUDIO OUTPUT JACKS
This projector uses a micro processor to control the
unit. Occasionally, the micro processor may
malfunction and need to be reset. This can be done
by pressing the RESET button with a pen, which will
shut down and restart the unit. Do not use the
RESET function excessively.
RESET BUTTON
When using the Wired / Wireless
Remote Control Unit as the Wired
Remote Control, Connect the Wired
Remote Control Unit to this jack with
the Remote Control Cable (supplied).
(Refer to page 19.)
R/C JACK
USB PORT
analog RGB
R/Pr G/Y B/Pb H/HV V
PC control
DVI
INPUT
-1
R/C jack USB
reset
(mono)
(mono)
(mono)
(mono)
(mono)
PC control
audio
PC control
S-video video/Y C
INPUT
-2
INPUT
-3
INPUT
-4
audio
audio
audio
serial port IN
serial port OUT
R L
audio OUT
R L
R
R
R
L
L
L
SERIAL PORT
OUT TERMINAL
SERIAL PORT
IN TERMINAL
This port is used to control the
projector with the computer. It is also
used to control the computer with the
Remote Control of this projector.
(Refer to P40, 42.)
Connect the USB port of the
computer to this port.
If you control the projector by computer,
you must connect a cable (not provided)
from your computer to this terminal.
This terminal outputs the
signal from SERIAL PORT
IN. More than two projectors
can be controlled with one
computer by connecting
SERIAL PORT IN. of another
projector to this terminal.