Proxima ASA Proxima PROAV9350 - Manual (Page 19)

19
Used to adjust zoom.
(P24)
volume
power
focus zoom
input 3/4
input 1/2 d.zoom
menu
mute
laser
keystone
blank freeze
auto image normal
lens shift
p-timer
loc
k
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the Remote Control Unit to moisture, or heat.
● Do not drop the remote control unit.
● If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
Press the lid down-
ward and slide it.
Remove the battery
compartment lid. Slide the batteries into
the compartment. Replace the compartment
lid.
Two AA size batteries
For correct polarity (+
and –), be sure the
battery terminals are in
contact with the pins in
the compartment.
REMOTE CONTROL BATTERIES INSTALLATION
1 2 3
Operating Range
Point the remote control toward the
projector (Receiver Window)
whenever pressing the buttons.
Maximum operating range for the
remote control is about 16.4’ (5m)
and 60° in front and rear of the
projector.
16.4’
(5 m)
60°
16.4’
(5 m)
MUTE BUTTON
Used to mute sound. (P26)
ZOOM BUTTON
FOCUS BUTTON
Used to adjust focus.
(P24)
NO SHOW BUTTON
Used to turn the picture
into black image. (P25)
AUTO IMAGE BUTTON
Use to operate AUTO
IMAGE function. (P33)
VOLUME BUTTON
Used to adjust volume.
(P26)
D.ZOOM BUTTON
KEYSTONE BUTTON
Used to correct the
keystone distortion.
(P24, 34, 38)
FREEZE BUTTON
Used to freeze the picture.
(P25)
NORMAL BUTTON
Used to reset to normal
picture adjustments preset
by the factory. (P33, 38)
WIRED REMOTE JACK
When using as the Wired
Remote Control, connect the
Remote Control Cable to this
jack. The battery installation
is required when using as the
Wired Remote Control.
BEFORE OPERATION
60°
LENS SHIFT BUTTON
Used to select LENS
SHIFT function. (P24)
Used to select DIGITAL
ZOOM mode and resize
the image. (P34)