Panasonic KX-FPG378 - Manual (Page 75)

8. Programmable Features
73
3. Press {1} to select “ ON”.
4. Press {SET}.
5. Enter the transfer telephone number, up to 30
digits.
6. Press {SET}.
7. Press {MENU}.
{#}{ 6}{1} Checking, recording or erasing
the transfer greeting message
TRNS-GREETING
CHECK [ ±]
{ 1} “ CHECK” (default)
{ 2} “ RECORD”
{ 3} “ ERASE”
See page 65 for details.
{#}{ 6}{7} Setting the incoming message
monitor
ICM MONITOR
MODE=ON [ ±]
To hear an incoming message (ICM) from the
speaker when the answering machine is
recording the message.
{
1} “ ON” (default): You can monitor the incoming
message.
{
2} “ OFF”: Deactivates this feature.
{#}{ 7}{0} Calling your pager
PAGER CALL
MODE=OFF [ ±]
{ 1} “ ON”
{ 2} “ OFF” (default)
See page 65 for details.
{#}{ 7}{2} Setting flash time
SET FLASH TIME
MODE=700ms [ ±]
The flash time depends on your telephone
exchange or host PBX.
{
1} “ 90ms”
{ 2} “ 100ms”
{ 3} “ 110ms”
{ 4} “ 250ms”
{ 5} “ 300ms”
{ 6} “ 400ms”
{ 7} “ 600ms”
{ 8} “ 700ms” (default)
Note:
L If the unit is connected via a PBX, PBX
functions (transferring a call etc.) might not
work correctly. Consult your PBX supplier for
the correct setting.
L You can also program this feature with the
handset (page 76).
{#}{ 7}{5} Setting the Caller ID number auto
edit feature
CALLER ID EDIT
MODE=ON [ ±]
{ 1} “ ON” (default)
{ 2} “ OFF”
See page 42 for details.
{#}{ 7}{6} Setting the connecting tone
CONNECTING TONE
MODE=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use those tones to confirm the status of the other
party’s machine.
{
1} “ ON” (default): You will hear connecting
tones.
{
2} “ OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
{#}{ 7}{7} Changing the receiving mode in
the AUTO ANSWER setting
AUTO ANSWER
MODE=TAM/FAX [ ±]
{ 1} “ TAM/FAX” (default): Telephone Answering
Machine/Fax mode (page 52)
{
2} “ FAX ONLY”: Fax only mode (page 53)
{#}{ 8}{0} Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [ ±]
{ 1} “ YES”
{ 2} “ NO” (default)
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {1} to select “ YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
FPG379-PFQX2138ZA-en.book Page 73 Wednesday, January 12, 2005 4:49 PM