Pioneer PDP-505CMX Plasma Display Panel RS-232 - Manual (Page 2)

2
RS-232C Adjustment Mode
1.0 RS-232C Adjustment Mode
This display panel has an RS-232C terminal. It is possible to use a PC to make adjustments and settings.
1.1 About the RS-232C Adjustment Mode
1) Adjustments in the RS-232C adjustment mode:
• The adjustments are written to the same memory area as for the integrator mode. Refer to section 5.4.4,
“PICTURE, White Balance and SCREEN Position Adjustment Values Memory Area Tables" (pg. 211).
2) Display screen in the RS-232C adjustment mode:
• The screen appears as shown to the right.
The set ID is display in the ‘– –’ area in the upper left corner
of the screen.
(1) Always assign an ID before using the RS-232C adjustment mode. Also, include the ID for the set
to be controlled or adjusted in the RS-232C command. For details, refer to section 5.5.2, “Interface"
(pg. 217).
(2) There are some RS-232C commands that can be used in the normal-operation mode.
For details refer to section, 5.5.5, “List of RS-232C Commands" (pg. 221).
(3) Some adjustment values and items set by RS-232C commands are stored in memory while other values
sand settings are not. For details, refer to section 5.5.5, “List of RS-232C Commands" (pg. 221).
Also, when storing final values in memory, the conditions described in section 5.1.5, “Last Memory"
(pg. 152), must be satisfied.
(4) <DIN>/<DIY> (OSD display disable/enable setting)
The following items can be displayed regardless of the setting:
• Menu display (menu mode, integrator mode)
• Warnings before Auto Power OFF or Power Management operation
• Warning of high temperature inside the set
• Display announcing that the FUNCTIONAL LOCK is set, and the FUNCTIONAL LOCK setting display
• Display call (including holding a button down)
(5) The RS-232C adjustment mode is automatically cancelled in the following cases:
• When the [STANDBY/ON] or [MENU] button is pressed
(6) Cancel the Integrator mode before entering the RS-232C adjustment mode.
(6) When controling the panel using RS-232C commands, control both the input signal and the power. If
the power is ON when there is no signal, the display continues to have a weak discharge. A discharge
could affect the life of the display.
AD J U S ME T N T
1 2 8 0 X 0 2 1 4@6 0H z – –
Notes