Pacific Cycle BRIGHT LIGHT ENERGY HF3305 - Manual (Page 50)

43
figure 1
figure 2
Fenders
Front Fender
The front fender is mounted at the fork crown. There are two
ways in which to mount your front fender. The first is the caliper
brake mounting system (see figure 1), and the second is the
10mm nut and bolt system (see figure 2). Identify the mounting
system used on your bicycle and follow the given instructions for
that particular type of mounting system.
1. Caliper Brake Mounting System
First remove the front wheel from your bicycle. Remove the
hex nut from the caliper brake bolt on the rear of the fork,
and slide the brake assembly from the fork. Place the fend-
er assembly onto the fork making sure the attachment holes
and fender bracket holes line up. Reattach the caliper
brake making sure that the brake arms are on each side of
the fender. Tighten the bolt until secure.
2. 10mm Nut and Bolt Mounting System
First remove the front wheel from your bicycle. Place the
fender assembly onto the fork making sure the attachment
holes and fender bracket holes line up. Attach the fender
with the 10mm hex bolt and nut. Tighten the bolt until secure.