Pacific Cycle BRIGHT LIGHT ENERGY HF3305 - Manual (Page 51)

44
Rear Fender
The rear fender is mounted at the seatstay brace. There are two
ways in which to mount your rear fender. The first is the screw
mounting system (see figure 3), and the second is the 10mm bolt
and screw system (see figure 4). Identify the mounting system used
on your bicycle and follow the given instructions for that particular
type of mounting system.
1. Screw Mounting System
First remove the rear wheel. Place the fender assembly
between the stays, making sure the fender bracket holes
line up with those in the frame. Attach the fener by using
two screws to directly mount the fender onto the frame.
The mounts are located below the seat post and near the
rear of the crank. Tighten all screws until snug.
2. 10mm Bolt and Screw System
First remove the rear wheel. Place the fender assembly
between the stays, making sure the fender bracket holes
line up with those in the frame. Attach the fender by using
one screw to directly mount the fender onto the frame near
the crank. Next, use the 10mm hex bolt and nut to attach
the fender to the brace between the seat stays, near the
seat post. Tighten all bolts and screws until snug.
figure 3
figure 4