Pacific Cycle BRIGHT LIGHT ENERGY HF3305 - Manual (Page 67)

60
Attaching Training Wheel Brace to Bicycle
There are two different braces used to attach the training
wheels to the bicycle: the C-Shape Brace and the Flat Brace.
Determine which brace was included with your bicycle and fol-
low the given instructions for that particular brace.
C-Shape Brace
Remove the axle nut and washer from the rear wheel axle.
Place the brace stabilizer washer onto the axle and align the
washer so that the notch on the washer fits into the rear frame
drop out. Next, place the C-shaped wheel brace onto the axle
and replace the washer and axle nut. Tighten the axle nut
securely, making sure that the wheel brace stays in the proper
vertical position. The elongated hole on the wheel brace
allows the training wheel height to be adjusted for proper fit.
Flat Brace
Remove the axle nut and washer from the rear wheel axle.
Place the flat wheel brace onto the axle. Next place the brace
stabilizer washer onto the axle and align it so that the notch
fits into the rear frame drop out. Replace the washer and axle
nut. Tighten the axle nut securely, making sure that the wheel
brace stays in the proper vertical position. The elongated
hole on the wheel brace allows the training wheel height to be
adjusted for proper fit.
C-Shape
Flat