Pacific Cycle BRIGHT LIGHT ENERGY HF3305 - Manual (Page 58)

51
Brake pad aligned with the rim surface Pad and rim should be parallel Pad should be “toed-in”
1- 2 mm
Cantilever Brakes - Utilizing a Straddle Cable
The length of the straddle cable, the height of the straddle hanger,
and the brake pad-to-caliper arm position all have an effect on brak-
ing power. Generally, the straddle cable bridge is set low and close
to the tire for maximum braking force. The straddle cable should be
high enough, however, to adequately clear the tire (and any debris
that may stick to the tire) or to fit over the front reflector hanger. In the
event of brake cable failure, the front reflector hanger would prevent
the straddle cable from catching in the tire and locking up the front
wheel. The straddle cable length (when adjustable) is set to transfer
as much force to the brake pads as possible. For the most efficient
transfer of force, the straddle cable and the line between the cantilever
pivot and the cable anchor should form a right angle (90 degrees). If
the force is not at a right angle, part of the force gets wasted in pulling
on the brake post, which has no effect on braking.
Straddle
Cable
Brake
Brake Cable
Straddle Hanger
Straddle Cable
Cable
Anchor
Caliper Arm
Pinch Bolt
Pivot
90 o
0.5 - 1.0 mm