PelPro Wood Pellet Stoves HSPP2 - Manual (Page 18)

18
M M
OBILE OBILE
H H
OME OME
I I
NSTALLATION NSTALLATION
CAUTION: DO NOT INSTALL STOVE IN SLEEPING ROOM
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR,
CEILING and ROOF MUST BE MAINTAINED!
Your PelPro Series appliance has been tested and listed for mobile home installation. It may be
installed in a mobile home as a "Free Standing Stove" or a "Hearth Stove", see detailed install and
clearance requirements in these sections as they imply there.
In addition to all previously detailed installation requirements, mobile home in-stallations
must meet the following requirements in accordance with the Manufactured Home and
Safety Standard (HUD) CFR 3280, Part 24:
Permanently bolt your stove to the floor, (A), figure 25.
Electrically ground your stove or the pedestal to the steel frame of the home. Use a number 8 gauge
copper wire, (B), figure 25, or equivalent.
The stove must have a permanent outside air source with a ¼ inch screen over the inlet.
Figure 26, (B, C & D)
For transportation all chimney/vent above the mobile home must be removed.
Chimney/PL Vent must be 3” or 4” PL Vent and must extend a minimum or 36” above the roofline
of the mobile home and must be installed using a UL / ULC listed ceiling fire stop (J), figure 26,
and rain cap (L), figure 26.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
Figure 25
Figure 26
Note: When moving your mobile home, all exterior venting must be removed. Upon completion of relocation,
all venting must be reinstalled, gas tight, and securely fastened.
A Floor Pad
B Combustion Air Intake
C Fresh Air Duct
D Fresh Air Hood
E Stove Exhaust
F Pipe Adapter
G Clean Out Tee
H Tee Support Bracket
I Pipe
J Firestop Spacer / Ceiling Support
K Roof Flashing / Storm Collar
L Rain Cap
B
A
C D
E F
G
H
J
K
L
FRAME
HEARTH PAD
FLOOR
B
GROU ND
WIR E
A
BOLT(S)
PelPro Home & Shop Heater www.pelprostoves.com 18