PelPro Wood Pellet Stoves HSPP2 - Manual (Page 24)

24
OPERATING IN THERMOSTAT HIGH / LOW CYCLE (Flashing 3 & 4)
This requires purchasing the optional “Wall Thermostat Add-on Kit”.
This mode of operation is preferred over the ON/OFF mode, during those long and chilly winter nights. The life of the Auto
Igniter is greatly increased, and once you have the room to temperature it does not take as much energy to keep it at that
temperature.
TO START
Once this mode has been selected, you simply press the START touch pad to
activate the stove.
TO ADJUST HEAT
You can now select the HIGH heat output level (2,3 or 4) by pushing the
START / FEED RATE touch pad, you can also select the FAN setting you desire.
When you have selected your high level and fan speeds the LED’s will continue
to flash. The appliance will automatically start at the #1 feed rate until the Start-
up procedure is complete.
The LOW (number 1) or selected High (2,3 or 4) Feed Rate indicator light will
light up depending on if the thermostat is calling for heat or not. When the
desired room temperature is reached the stove will automatically go into the low
heat (#1) cycle. When the temperature in the room drops to the level set at the
thermostat, the stove will again cycle to the HIGH (#2,3 or 4) preselected set-
ting. For optimum heat transfer, the FAN setting should be set at LOW or
MEDIUM. The appliance will run the FAN at HIGH speed when needed,
automatically.
TO SHUT DOWN
To turn off the appliance press the OFF touch pad.
TO START … con’t
After Pushing the START touch pad:
The appliance will automatically start in the #1 or low feed rate,
no matter where you set it.
When the FEED RATE LED is flashing FAST, this indicates the
unit has not reached 120° F exhaust temperature.
When the FEED RATE LED flashes at a SLOWER rate, this
indicates the control has reached the 120°F temperature
and as entered a 5 minute “Safety Delay”
When the 5 minute “Safety Delay” is complete the IGNITER
LED and igniter will turn off and the FEED RATE LED will
become solid, meaning you are now in control.
TO ADJUST HEAT
Simply press the START/FEED RATE touch pad to adjust heat output.
Note: During start-up you may adjust the feed rate. This setting will take affect once the
Start-up sequence is complete.
TO SHUT DOWN
Press the OFF pad.
O O
PERATING PERATING
I I
NSTRUCTIONS NSTRUCTIONS
Feed Rates 3 & 4
PelPro Home & Shop Heater www.pelprostoves.com 24