Pentax PocketJet 3 - Manual (Page 24)

Connecting to Your Computer
There are two ways to connect your PocketJet to your computer,
via USB cable and via Infrared (IrDA). Optionally, you can
connect via a wireless Bluetooth or a wired Serial connection if
your printer is factory-configured for these methods.
Via USB Cable
CAUTION: Install the driver software before connecting the printer
to the computer via the USB cable.
1. Make sure your printer is off before installing the interface cable.
2. Take the printer end of the cable and hold it so the notched metal
surface is facing up.
3. Insert the printer end of the cable into the interface connector on the
side of the printer. See example, Figure 7
FIGURE 7. Connecting the PocketJet to your computer
CAUTION: Always insert and remove the interface connector
gently. Press the latching devices on each side of the
interface connector when removing the cable.
4. Connect the other end of the cable to the USB port on your
computer.
Note 1: USB is not supported for Windows 95.
Note 2: For Windows 98/98-SE, USB printing requires installing Microsoft’s
USBPRINT solution. To install this software:
A. Connect the USB cable to the printer and computer.
Page 14