Pentax PocketJet 3 - Manual (Page 68)

Paper Problems
The paper is jammed in the printer
See page 45, “Clearing a Paper Jam.”
Paper moves through the printer, but nothing appears
on the paper
Make sure you are using Pentax Quality paper and that you are loading
it properly with the print side away from you. See page 43, “Inserting
Paper.” Also, check the Print Density setting using the “Advanced
Software Features,” Chapter 2.
Paper does not move through the printer even though
the motor is running
If the release cover has been left open, close it completely.
Use Pentax Quality paper only. Heavy paper may not feed through the
printer.
If the release cover is closed and you are using Pentax Quality paper,
the printer may have a damaged drive system. Call technical support.
Printed Image Problems
The printed image is out of alignment
Make sure you are using the Pentax Quality paper.
Make sure you are inserting the paper correctly. See page 43,
“Inserting Paper.”
Check to see whether the platen roller is dirty. If it is, clean it. Follow
the instructions for “Cleaning the Platen Roller,” page 49.
The print quality is poor, and the image is too light or
dark
Raise or lower the density setting using the printer driver. See page 17,
“Making Prints Lighter or Darker.”
Make sure you are using recommended Pentax Quality Paper.
Page 58