Pride Mobility JAZZY 1170 XL PLUS - Manual (Page 32)

32 www.pridemobility.com Jazzy 1170 XL Plus
V I I . O P E R A T I O N
Horn Key
The horn key activates the horn.
Locking/Unlocking the VSI
The VSI has a feature that enables you to lock your power chair to prevent unauthorized use.
To lock the VSI:
1. With the VSI switched on, press and hold the on/off key. After 1 second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
To unlock the VSI:
1. Press the on/off key and power on the VSI. The maximum speed/profile indicator should ripple side to side.
2. Push the joystick to the full forward position until the VSI beeps.
3. Pull the joystick to the full rearward position until the VSI beeps.
4. Release the joystick. There should be a long beep.
5. The VSI is now unlocked.
NOTE: If the above procedure fails to either lock or unlock the VSI, contact your authorized Pride Provider.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front
of the VSI. If you use an off-board charger, the charger current should not exceed 8 amps. Contact your autho-
rized Pride Provider for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the onboard
charger/programming socket. See your authorized Pride Provider for more information.
NOTE: The socket may also be used for reprogramming the VSI. Contact your authorized Pride Provider
for more information.
Actuator Connector
The actuator connector connects the VSI to optional powered systems such as an elevating seat or lighting system.
Contact your authorized Pride Provider for information on how to operate these accessories.
Controller Connector
This connects the VSI to the power chair’s batteries, motors, and motor brakes.