Pride Mobility JAZZY 1170 XL PLUS - Manual (Page 34)

34 www.pridemobility.com Jazzy 1170 XL Plus
V I I . O P E R A T I O N
REMOTE PLUS CONTROLLER
The electronic controller is what you use to operate your power chair. It takes the battery voltage and sends it to
the appropriate system. The electronic controller also enables you to monitor battery charge, electronic controller
functions, and the condition of your electrical system. Also, it may be used to control some optional systems such
as a power elevating seat and lights through an actuator/lighting module (ALM) located on the power base. The
Remote Plus electronic control system is a modular system. The electronics necessary to operate your power chair
are contained in several modules located on different parts of your power chair. Typically, the Remote Plus joystick
is mounted to one of the armrests. It is connected to a power module located on the power base through the
controller communications connector.
The controller supplied with your power chair has been pre-programmed to meet your needs. The program is set
using either a personal computer with software provided by the controller manufacturer or with a hand-held
programmer, also provided by the controller manufacturer.
WARNING! The controller program can affect speed, acceleration, deceleration, and
braking. If it is programmed incorrectly or outside of the safe limits as determined by your
healthcare professional, it can create a dangerous situation. Only the power chair
manufacturer, an authorized representative of the manufacturer, or a trained service
technician should program the controller.
The Remote Plus master remote consists of the following (see figure 22):
1
2
3
4
Figure 22. Remote Plus Master Remote
1. joystick
2. keypad
3. controller communications cable
4. off-board charger/programming socket
Joystick
The joystick controls the direction and speed of your
power chair. When you move the joystick from the neu-
tral (center) position, the electromagnetic brakes release
and allow your power chair to move. The farther you
push the joystick from its neutral position, the faster your
power chair moves. When you release the joystick and
allow it to return to the neutral position, you engage the
electromagnetic brakes. This causes your power chair to
decelerate and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately
release the joystick. Unless the joystick is damaged, this action should stop your power
chair.
Keypad
The keypad is located directly in front of the joystick. See figure 23. It contains keys that you will use to control
your power chair.