Pride Mobility JAZZY 1170 XL PLUS - Manual (Page 43)

Jazzy 1170 XL Plus www.pridemobility.com 43
V I I I . C A R E A N D M A I N T E N A N C E
CARE AND MAINTENANCE
Your Jazzy 1170XL Plus is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance
checks. You can perform some of these checks, but others require assistance from an authorized Pride Provider.
Preventive maintenance is very important. If you follow the maintenance checks in this section as scheduled, you
can help ensure that your power chair gives you years of trouble-free operation. If you have any doubt as to your
power chair’s care or operation, contact your authorized Pride Provider.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp areas of
any kind.
WARNING! Direct exposure to water or dampness could cause the power chair to
malfunction electronically and mechanically. Water can cause electrical components to
corrode and the chair’s frame to rust.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a dry towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to an authorized Pride Provider.
Temperature
! Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your
power chair between the temperatures of 18° F and 122° F.
! In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze de-
pends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM or
Gel-Cell).
! Temperatures above 122° F may cause your power chair to operate at a reduced speed. This reduced speed
is a safety feature built into the controller that helps prevent damage to the motor and other electrical compo-
nents. See VII. “Operation.”
General Guidelines
! Avoid knocking or bumping the controller, especially the joystick.
! Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
! Keep the controller clean.
! Check all connectors on the electronics tray to ensure that they are all tight and secured properly.
WARNING! Make sure your tires are inflated to 35 psi (2.4 bar). Do not underinflate or
overinflate your tires. Low pressure may result in loss of control, and overinflated tires
may burst. Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.
! Use a rubber conditioner on the tire sidewalls to help preserve them.
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may
make the tires slippery and cause your power chair to skid.