Pioneer DVR-230-S - Manual (Page 49)

The Initial Setup menu 08
49
En
There are three different recorder IDs. When set to
Recorder2 or Recorder3 , the remote control mode is
shown in the front panel display.
After selecting a new recorder ID, you have to confirm the
change by selecting
Yes or No (use the / buttons),
then pressing ENTER .
Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.
To set the remote, press and hold RETURN and a number
button ( 1 , 2 or 3 ) for five seconds.
Setup Navigator
• Default setting: n/a
The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.
See also Switching on and setting up on page 18.
Power Save
• Default setting: Off
When set to Off , signals arriving at the ANTENNA IN
terminal are passed through to the ANTENNA OUT
terminal when the recorder is in standby.
• On – No through function for the antenna terminal
• Off – Through function for the antenna terminal
Remote Control
Recorder1 Remote Control
Remote Control
Recorder2 Remote Control
After changing this setting, the remote
control mode must be changed.
OK to Continue ?
No Yes
Basic
Disc
Video
Audio
Recording
Playback
Clock
Tuner
OSD Language Clock
Tuner
OSD Language
Display
Remote Control
Power Save
Basic
Setup Navigator
Basic
Disc
Video
Audio
Recording
Playback
Clock
Tuner
OSD Language
Display
Remote Control
Basic
Setup Navigator
Power Save
Power Save
Power Save
Off
DVR-230_YP.book Page 49 Monday, July 4, 2005 5:20 PM