Pioneer DVR-545HX-S - Manual (Page 157)

Additional information 17
157
En
No picture • Check that everything is connected properly (page 14).
• Check that the connected TV and/or the AV amp/receiver is set to
the correct input.
• The recorder may be set to progressive scan with an incompatible
TV. Reset to interlace by pressing and holding the front panel
STOP
button then pressing ONE TOUCH COPY .
• If you are using an indoor antenna that requires power, make sure
that
Aerial Power in the Initial Setup menu is set to On or Auto
(page 139).
• If the aerial/antenna is not connected properly, or if it is shorted, the
Aerial Power setting will revert to Off automatically. Check the aerial
connection and try making the setting again.
All settings are reset • If the recorder is unplugged (or there is a power failure) while the
recorder is on, all the settings will be lost.
• Make sure that you switch the recorder into standby before
unplugging the power cord.
Remote control does
not work • If you connected this recorder to another Pioneer product using the
CONTROL IN jack, point the remote control at the other component to
use (page 14).
• Set the remote control to the same ID number as the recorder
(page 149). (When the batteries run down, the remote mode is
automatically reset to
Recorder1 .)
• Use the remote within its operating range (page 7).
• Replace the batteries (page 6).
No sound or sound is
distorted • Make sure that the amp/receiver or TV is set to the correct input and
the volume turned up.
• There is no sound when the picture is paused, or during scanning or
slow motion play. Press
PLAY to resume regular playback.
• DTS discs can only be played if this recorder is connected to a DTS
decoder or DTS compatible amp/receiver. If you have connected a
suitable decoder, also make sure that the
Initial Setup > Audio Out >
DTS Out setting is On .
• Some 96 kHz discs do not output audio through the digital jack. In
this case, switch the input of your amp/receiver to analog.
• Check the audio cable connections (page 14).
• If the sound is distorted, try cleaning the cable plugs.
Cannot switch a bilin-
gual program • During real-time copying it is not possible to switch audio channels.
The main and sub channels are both output.
The picture from the
external input is
distorted • If the video signal from the external component is copy-protected,
you cannot connect via this recorder. Connect the component directly
to your TV.
The picture is distorted • Change the Input Line System setting (page 150). (You can also
change it by pressing the
STOP button and INPUT SELECT on the
front panel simultaneously with the recorder stopped.)
Problem Remedy
DVR940HX_UK_EN.book 157 ページ ２００６年７月１２日 水曜日 午後４時５分