Pioneer DVR-545HX-S - Manual (Page 69)

Recording 07
69
En
Using the built-in A.TV and
D.TV tuners
Switching between A.TV and D.TV
tuners
• DVR-940HX-S:
• DVR-545HX-S:
Press to switch between D.TV (digital)
and A.TV (analog).
Changing channels
There are a number of ways to select analog
and digital TV channels. 1 Note that you can’t
change the TV channel during playback,
recording or during recording standby.
• DVR-940HX-S: Smart Jog
• DVR-545HX-S: CHANNEL +/–
buttons
• Number buttons
For example, to select channel 4 (digital
channel D004), press
4 then ENTER ; for
channel 34 (digital channel D034), press
3 , 4 , ENTER .
2
• CH +/– buttons on the front panel
• For D.TV channels only, you can also use
the Channel List—see below.
Tip
• When changing terrestrial digital
broadcast channels, channels with a low
signal strength may result in a black
screen being displayed.
• For other channels, it may take a short
while for the channel picture to appear,
and/or for the channel number to
appear.
• In both of the above cases, some
improvement may be possible by
adjusting the antenna.
Using the D.TV Channel List
When in D.TV mode, you can call up the on-
screen Channel List anytime by pressing
ENTER . Use the / buttons to select a
channel, then press ENTER to switch to that
channel.
1
Note
1 • If you select a locked channel, you will need to enter your password to access it.
• While listening to D.TV radio channels, the screen saver automatically starts after no button has been pressed
for 3 minutes.
2 Analog channel presets are numbered 1 to 99; digital channel presets are numbered D001 to D999.
A.TV/D.TV
SHIFT
+
A.TV/D.TV
CHANNEL +
– CHANNEL
PREV NEXT
CHANNEL
D001
D002
D003
D004
************
************
******
************
D005
D006
****
******
DVR940HX_UK_EN.book 69 ページ ２００６年７月１２日 水曜日 午後４時５分