Polaroid Polaview 220 User Manual
Page 10
Note:
Whenever you connect the projector to a computer or
video source for the first time, the projector defaults to the
factory settings. Due to operational differences between
computers and video sources, it may be necessary to make
minor adjustments to the settings. See
Image optimization
in Chapter 4,
Using the projector
for more information. The
projector stores any modified settings, even when the
power is turned off.
Note:
Audio and video sources must be connected to the
same computer or video source to be selected simultane-
ously.
7 To activate audio, connect the audio cables (from your com-
puter, compact disc player, stereo, etc.) to the STEREO port
that corresponds to the source connected in step 2. The
audio source plays through speakers built into the projector.
You may also connect amplified speakers or headphones to
the OUTPUT connector labeled STEREO or L and R. This
automatically deactivates the projector speakers.
Note:
If you connect a mono or single-jack stereo source to
the left (L) audio port (with nothing plugged into the right
(R) audio port), the sound emanates from both speakers.
8 Begin your presentation.
Note:
For setup procedures for the Computer IR (infrared)
Receiver, refer to the separate instruction manual included
in your Computer IR Receiver Kit.
6 Introduction