Polaroid Polaview 220 - Manual (Page 19)

Supplying power to the projector
After you connect the projector to your computer or video
source, connect the power cord to the projector. The power-
cord receptacle and AC power switch are located below the
connector panel on the rear side of the projector.
Power receptacle
and AC power
switch
a Power receptacle
b AC power switch
To supply power to the projector:
1 Plug the appropriate power cord into the power receptacle
on the rear panel of the projector.
2 Connect the power cord to a properly-grounded wall outlet.
Detailed setup 15
VIDEO INPUTS
CAUTION !
For continued protection
replace only with the sam
Double pole / Neutral fusi
Type and Rating: T Slow-
Input: 120/230V~
60/50Hz,5.0/2.5A
a
b