Panasonic WV-NP304 - Manual (Page 10)

Cleaning the lens
Use a lens cleaning paper (used to clean
camera lenses or lenses of spectacles).
When using solvent, use an alcohols solvent.
Do not use a thinner or a glass cleaner.
Refresh interval
Image refresh interval may become slow
depending on the network environment, PC
performance, shooting subject, access traf-
fic, etc.
SD memory card
• When insert an SD memory card into the
SD memory card slot, turn the power of
the camera off. Otherwise, it may cause
malfunction or damage data recorded on
the SD memory card.
Refer to page 28 for descriptions of how
to insert/remove an SD memory card.
• When using an unformatted SD memory
card, format it using this camera.
Recorded data on the SD memory card
will be deleted when formatted.
If using an unformatted SD memory card
or using an SD memory card formatted
with other device, the camera may not
work properly or performance deteriora-
tion may be caused.
Refer to the setup instructions (PDF) for
descriptions of how to format an SD
memory card.
• It is recommended to use Panasonic’s
SD memory cards (64 MB, 128 MB, 256
MB, 512 MB, 1 GB, and 2 GB) since they
have tested and confirmed full compati-
bility with this camera.
If another SD memory card is used, the
camera may not work properly or per-
formance deterioration may be caused.
10
Precautions
To continue using with stable perform-
ance
Parts of this product may deteriorate and it
may shorten the lifetime of this product when
using in locations subject to high tempera-
tures and high humidity.
(Recommended ambient temperature: 35°C
or below)
Do not expose the product to direct heat
such as from a heater.
Handle this product with care.
Do not strike or shake, as this may damage
the product. It may cause a malfunction.
About the PC monitor
When displaying the same image on the CRT
PC monitor for a long time, the CRT PC moni-
tor may be damaged. It is recommended to
use a screen-saver.
When an error is detected, the camera will
reboot automatically.
This camera will reboot when detecting an
error caused by any reason. The camera will
be inoperable for around 30 seconds after
the reboot just as when the power is turned
on.
Cleaning the camera body
Turn the power off when cleaning the cam-
era.
Otherwise, it may cause injury.
Do not use strong abrasive detergent when
cleaning the camera body.
Otherwise, it may cause discoloration.
When using a chemical cloth for cleaning,
read the caution provided with the chemical
cloth product.
When the dirt is hard to remove
Use a mild detergent and wipe gently.
Then, wipe the detergent completely off with
a dry cloth.