Panasonic WV-NP304 - Manual (Page 20)

20
Attach a safety wire
The following is a safety wire attachment example. Procure an appropriate safety wire kit
according to the installing place.
Refer to the operating instructions of the safety wire kit in use together with this installation
guide when attaching a safety wire.
Important:
• To prevent the camera from dropping that may cause accidental injury, attach a safety
wire between the camera and the installing place. Contact your dealer for attachment of a
safety wire.
When installing on a ceiling
<Required camera mount bracket and safety wire kit>
• Camera mount bracket: WV-7010A
• Safety wire kit: WV-Q141
z
Detach the tripod mount base from the camera.
x
Fix the tripod mount base and the safety
wire attachment bracket for ceiling
mount (provided) using the fixing screw.
Use the removed screw (used to fix the
tripod mount base).
When a screw other than the removed
screw (with a different height) is used, it
may result in drop or damage of the
camera.
Recommended tightening torque: 0.39
N·m
c
Attach the two safety wires to the safety wire attachment holes (front/rear).
q Pass the loop end of the safety wire through the safety wire attachment hole.
w Hook the loop end of the safety wire on the safety wire hook.
Safety wire attachment hole
Safety wire Safety wire hook
Installation
T
Tripod mount base
Fixing screw
Safety wire
attachment
bracket for ceiling
mount (provided)
Safety wire
attachment hole
(rear)
Safety wire
attachment hole
(front)