Pioneer DJm-909 - Manual (Page 5)

5
<DRB1349>
CONNECTIONS
When connecting or changing the connection of units, make sure to first turn off the power switch and disconnect the power cord
from the outlet.
This mixer is not furnished with any connection cables; when performing connections, use the cables that came provided with your
player and other components, or purchase commercially available audio cables.
1. Connecting Input Components
÷ Hexagonal Allen driver
(for cross fader operating load adjust screw)
DJ CD Players 1
Connect the AUDIO OUT connectors from Player A to the
CH-1 CD input jacks of the DJ mixer, and connect the AUDIO
OUT connectors from Player B to the CH-2 CD input jacks.
When using one of the listed DJ CD players, the control cord
furnished with the CD player should be connected between
the player and the DJ mixer. In this way, the DJ mixer’s fader
lever can be operated to control operation of the DJ CD
player for fader start play and back cue.
Analog turntable / Cassette deck, etc. 2
Connect the analog turntable 1 output cables to the CH-1
PHONO/LINE jacks of the DJ mixer, and connect the ground
wire to the SIGNAL GND terminal. Set the CH-1 PHONO/
LINE selector switch to [PHONO]. When connecting a
cassette deck or other such component to these jacks, set
the CH-1 PHONO/LINE selector switch to [LINE].
Connect the analog turntable 2 output cables to the CH-2
PHONO/LINE jacks of the DJ mixer, and connect the ground
wire to the SIGNAL GND terminal. Set the CH-2 PHONO/
LINE selector switch to [PHONO]. When connecting a
cassette deck or other such component to these jacks, set
the CH-2 PHONO/LINE selector switch to [LINE].
* The PHONO input for this DJ mixer supports use of a MM
cartridge.
MIC 3
The MIC jack on this unit supports use of either PHONE type
or XLR type plugs.
SESSION IN 4
When using multiple mixers simultaneously, use the
appropriate audio cables to connect the other mixer outputs
to these jacks.
CD
MASTER 1
CH-2
BOOTH/
SESSION OUT
PHONO
/ LINE
R L
MASTER 2
CH-1
3 COLD
1 GND
2 HOT
C ONTRAST B RIGHT
PHONO
/ LINE
PHONO
LINE SIGNAL
GND
(MONO) (MONO)
CD
MIC
PHONO
LINE SIGNAL
GND CH-2 PLAYER
CONTROL
CH-1 PLAYER
CONTROL
SESSION IN
R L
R
R L
R L
L
SEND RETURN
R R L L
R
L
R
L
R L R L R L
Analog turntable 2
Cassette deck, etc.
[DJ CD Player]
CDJ-800, CDJ-1000, CDJ-1000MK2,
CDJ-100S, CDJ-700S, CDJ-500II,
CMX-3000, CMX-5000, DMP-555
Player A
Analog turntable 1
Cassette deck, etc.
Microphone
Other mixer output
2
1 1
2
3
4
CH-2 PHONO/LINE
selector switch CH-1 PHONO/LINE
selector switch
Player B
CHECKING ACCESSORIES
÷ These operating instructions
÷ Warranty