Peugeot 205 - Manual (Page 181)

Bodywork and fittings 11•5
11
9.2 Front bumper components
1 Side mounting (non-GTI)
2 Side mounting (GTI)
3 Side bracket (non-GTI)
4 Bracket
5 Side bracket (GTI)
6 Seal clip
7 Seal
8 Bumper
9 Moulding
10 Mounting plate
11 Headlight washer bracket
9.8 Rear bumper components
1 Moulding
2 Mounting plates
3 Bumper
4 Side mounting and nut
5 Rubber buffer
6 Bracket
7 Mounting bolt
8 Nuts
9 Bracket nut and washers
10 Bracket
10 Door - removal and refitting 3
Removal
1 The door hinges are welded to the body
pillar and bolted to the door.
2 Remove the plastic caps from the hinge
pivot pins.
3 Drive out the roll pin from the door check
strap.
4 Where applicable, remove the trim panel
(Section 11) and disconnect the loudspeaker
wiring from the door.
5 Support the door in the fully open position
by placing blocks, or a jack and a pad of rag,
under its lower edge.
6 Drive out the hinge pivot pins and remove
the door.
Refitting
7 Refit by reversing the removal operations.
8 Where necessary, the striker on the body
pillar may be adjusted to ensure correct
closure of the door.