Pioneer Super Tuner III D AVH-P4950DVD - Manual (Page 42)

Initial Settings
Adjusting initial settings
Important
Following function cannot be operated in your
area. (Inoperable function is indicated in grays-
cale.)
— V.D.P. MIX
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
1 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Press A.MENU button and touch INIT to
display the initial function names.
The function names are displayed and oper-
able ones are highlighted.
# To go to the next group of function names,
touch
NEXT.
# To return to the previous group of function
names, touch
PREV.
# When the multi-channel processor (e.g., DEQ-
P7650) is connected to this unit, you can operate
D. ATT and RESET instead of REARSP.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
% Touch FMSTEP on the initial menu to se-
lect the FM tuning step.
Touching
FMSTEP will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
% Touch AMSTEP on the initial menu to
select the AM tuning step.
Touching
AMSTEP will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
Operating this unit
En
42
Section
03