Pioneer Super Tuner III D AVH-P4950DVD - Manual (Page 43)

% Touch D. WARN on the initial menu to
turn warning tone on.
# To turn warning tone off, touch D. WARN
again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
% Touch AUX on the initial menu to turn
auxiliary setting on.
# To turn auxiliary setting off, touch AUX again.
Setting the illumination switch
You can choose whether to have the illumina-
tion of this unit switch on/off when the ignition
key is turned to the ACC position or the power-
off position.
% Touch ILM SW on the initial menu to
turn the illumination switch on.
Set the illumination switch ON to have the illu-
mination of this unit remain on when the igni-
tion key is turned to the ACC position. Set to
OFF to have the illumination off when the igni-
tion key is turned to the ACC position.
# To turn the illumination switch off, touch
ILM SW again.
Note
Never set the illumination switch on if the vehicle
does not have the ACC position. It may cause bat-
tery leakage.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
FULL) or subwoofer (SUB. W)
connection. If you switch the rear output set-
ting to
SUB. W, you can connect a rear speak-
er lead directly to a subwoofer without using
an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
troller
’s (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.
! When the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you
cannot operate this function.
1 Touch NEXT on the initial menu.
2 Touch REARSP.
3 Touch a or b to switch the rear output
setting.
Touch a to select full-range speaker and FULL
appears in the display. Touch b to select sub-
woofer and
SUB. W appears in the display.
# When no subwoofer is connected to the rear
output, select
FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer
SUB. W.
# When the rear output setting is SUB. W, you
cannot change the subwoofer controller.
4 Touch c or d to switch the subwoofer
output or non fading output.
Touch c to select subwoofer output and
SUB.W appears in the display. Touch d to se-
lect non fading output and
FULL appears in
the display.
Operating this unit
En
43
Section
03
Operating
this
unit