Pioneer Super Tuner III D AVH-P4950DVD - Manual (Page 44)

Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 36)
or subwoofer output (refer to Using subwoofer
output on page 35) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
! Only when the multi-channel processor
(e.g., DEQ-P7650) is connected to this unit,
you can operate this function.
1 Touch NEXT on the initial menu.
2 Touch D. ATT to switch the digital at-
tenuator setting.
Touching
D. ATT switches the digital attenua-
tor settings in the following order:
HIGH
—LOW
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
1 Touch NEXT on the initial menu.
2 Touch TEL/GUIDE to select any of the
muting, attenuation or off.
Touch
TEL/GUIDE until the desired setting ap-
pears in the display.
! MUTE – Muting
! ATT 20 – Attenuation (ATT 20 has a stron-
ger effect than ATT 10)
! ATT 10 – Attenuation
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is muted or attenuated, MUTE or
ATT are displayed and no audio adjustment is
possible.
! Operation returns to normal when the phone
connection or the voice guidance is ended.
Resetting the audio functions
You can reset all audio functions except vo-
lume.
! Only when the multi-channel processor
(e.g., DEQ-P7650) is connected to this unit,
you can operate this function.
1 Touch NEXT on the initial menu.
2 Touch RESET.
3 Touch RESET.
4 Touch RESET again to reset audio func-
tions.
# To cancel resetting the audio functions, touch
CANCEL.
Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! This function is initially set to AUTO so that
this unit automatically adjusts the TV signal
setting.
1 Touch NEXT on the initial menu.
Operating this unit
En
44
Section
03