Pioneer BDP-V6000 - Manual (Page 71)

71
En
09
Network
The in put does not switch
automatically on the Flat
Panel TV and AV system (AV
receiver or amplifier, etc.)
when
playback is started on
the player or the Home Menu
o r Home Media Gallery is
dis played.
Is Display Power On set to
Off on the player?
Set Display Power On to On (page 44).
Problem Check Remedy
• BD-LIVE function
(connection to the Inte
rnet)
cannot be used.
• “Connection to the softwa re
u pdating server failed” is
dis played when you try to
u pdate the software.
Pe rform Connection Test (page 49). If “Network connection test
com pleted successfully.” is displayed, check the proxy server settings
( page 48). Also there may be a problem with the Internet connection.
Contact you r Internet service provider.
“OK to g rant network access
to BD a pplications?” is
dis played when a BD-LIVE
com patible disc is read.
• This is dis played for discs presenting security risks related to
connection to the Inte rnet. Normally select No when this is displayed.
To allow connection to the Inte rnet, select Yes.
• This may be dis played even if the disc does not support the BD-Live
function.
Softwa re updating is slow. De pending on the Internet connection and other conditions, some time
may be required to update the software.
The player stops operating
while softwa re is being
u pdated.
Softwa re updating takes 10 to 20 minutes. Wait until updating is
com pleted. DO NOT turn the power off while the software is being
u pdated. Doing so may result in an operation failure.
• “WRT NG ****” is dis played
on the f ront panel display
du ring software updating.
(**** meaning any
cha
racters)
• “WRT FAILED” is dis played
on the f ront panel display
du ring software updating.
The message is dis played when software updating has failed. Check
again whethe r it can be updated properly.
A message othe r than
“Netwo rk connection test
com pleted successfully” is
dis played when Connection
Test is performed.
Is “LAN cable not connected”
dis
played?
Check that this player and Ethernet hub (or router with hub
functionality) a re properly connected.
• Is “IP add ress cannot be
obtained.” dis played?
• Is “No response from the
gateway.” dis played?
• If the IP add ress is obtained using the DHCP server function, check
the setting is co rrect at the Display Network Configuration
( page 49). For details on the DHCP server function, see the operating
inst ructions of the Ethernet hub (or router with hub functionality).
• Set the IP add ress manually.
Is “IP add ress is overlapped.”
dis played?
• Check the o peration and settings of the DHCP server function of the
Ethe rnet hub (or router with hub functionality). For details on the DHCP
se rver function, see the operating instructions of the Ethernet hub (or
router with hub functionality).
• If this player’s has been set manually, reset the IP address of this
player or other components.
Is the Ethe rnet hub (or router
with hub functionality)
o
perating properly?
• Check the settings and o peration the Ethernet hub (or router with hub
functionality). Fo r details, see the operating instructions of the Ethernet
hub.
• Reboot the Ethe rnet hub (or router with hub functionality).
Problem Check Remedy
V6000_CUXJ_EN.book 71 ページ ２００９年６月５日 金曜日 午前１１時５７分