Pioneer VSX-D712 - Manual (Page 38)

Playing sources 05
38
En
• Press SIGNAL SELECT (front panel) to
select the input signal corresponding to
the source component.
Each press cycles through the options as
follows:
The AUTO setting automatically switches to
DIGITAL if a digital source is detected, other-
wise the signal select will be
ANALOG.
DVD 5.1ch (VSX-D712) and DVD 7.1ch (VSX-
D812) will only appear when
DVD/LD is
selected.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input,
and
DTS lights when a DTS signal is input.
• This receiver can only play back Dolby
Digital, PCM (32kHz–96 kHz) and DTS
digital signal formats (however, only the
VSX-D812 can decode DTS 96kHz/24 bit
signal formats). With other digital signal
formats, set to
ANALOG.
• You may get digital noise when a LD or CD
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 16) and
set the signal input to
DIGITAL.
• Some DVD players don’t output DTS
signals. For more details, refer to the
instruction manual supplied with your
DVD player.
Listening to multi-channel
playback
1 Switch on the playback component.
2 Turn on the power of the receiver.
3 Select the source you want to play-
back.
Use the
MULTI CONTROL buttons (or INPUT
SELECT).
4 Press STANDARD.
If the source is Dolby Digital, DTS, or Dolby
Surround encoded, the proper decoding
format will automatically be selected and
shows in the display.
If you are listening to a two channel source,
each press changes the display as follows:
Refer to page 36 for more details about each
mode.
DIGITAL
DVD 5.1 ch/
DVD 7.1 ch
AUTO
ANALOG
MULTI CONTROL
RECEIVER
STANDARD
DVD/LD TV / SAT
INPUT SELECT
C D
VCR/DVR TV CONT
TUNER CD-R/TAPE
MOVIE
(2 Pro Logic II)
(2 Pro Logic II)
PROLOGIC
MUSIC MUSIC
CINEMA
(Neo:6)
(Neo:6)