Pioneer VSX-D712 - Manual (Page 56)

Using the tuner 07
56
En
4 Press ENTER.
After pressing ENTER , the preset class and
number stop blinking and the receiver stores
the station.
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets below for how
to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. NAME , then a blinking
cursor at the first character position.
3 Input the name you want.
Names can be up to four characters long.
• Use the MULTI JOG dial (front panel) or
the ST +/– buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no
character is input, a space is input.
• The name is stored when ENTER is
pressed after choosing the fourth char-
acter.
• To erase a station name, simply repeat
steps 1-3 and input four spaces instead of
a name.
• Once you have named a station preset,
you can press DISPLAY when listening to
a station to switch the display between
the name and the frequency.
Listening to station presets
You will need to have some presets stored to
do this. See
Saving station presets on page 55
if you haven’t done this already.
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A,
B and C.
3 Press ST +/– (STATION +/–) to select
the station preset you want.
• If the receiver is left disconnected from
the AC power outlet for an extended
period, the station memories will be lost
and will have to be reprogrammed.