PYLE Audio PLDVCR500 - Manual (Page 12)

11
Rear Panel
VIDEO OUT Connector.
Connect this terminal to VIDEO IN terminal of your TV
, using the RCA cord .
Connect this terminal to VIDEO IN terminal of your TV
, using the RCA cord .
IR INPUT
Connect this terminal to remote control out.
DIGITAL OUT Connecter
S/W OUT Connector
Connect the TV antenna
(or cable if available- home use) to this
connector.
RF OUT Connector.
This connectors provides an interface
to the antenna input connectors terminal of your
television using a coaxial cable.
Tuner the television to channel 3 or 4
to watch video tapes.
DC JACK IN (DC 12V)
For car using, we recommend to use this connector
with 3-wire system.
* Connector description for 4
GND
ACC 12V
VEHICLE BATTERY 12V
ANT IN Connector.
DC 12V IN JACK ( Round type)
To use this connector, below Convert-Adapter
accessory should be locked into above connector 4.
( Convert-Adapter)
* Please note :
We highly recommend to connect the unit
corresponding to the 3-wire system of 4.
Thus, to make sure a proper working
of power-off tape guide.
Beyond it, the unit will automatically change
to standby mode after turning off the vehicle in
order to save the car battery.
Caution : Make use of AC/DC Adaptor
( Ripple Voltage: Max 500mV)
DVD OUT Connector.
AUDIO IN (AV1)
Connector this terminal to AUDIO OUT terminal of your
Game machine, Camcorder, using the RCA cord
For displaying this Rear A/V input connected, Input
Signal should be set to "AV1" in Menu setting mode.
Connect this terminal to VIDEO IN terminal of your TV
, using the RCA cord .
To enjoy sound quality of theater lev el in home,
connect this jac k with amp or unit embedded with
digital audio decoder