PYLE Audio PLDVCR500 - Manual (Page 15)

14
Connecting with TV
How to Connect with RF cable
INPUT 1
ANT IN
INPUT 2
REAR PANEL OF DVD-VIDEO
OUTSIDE ANTENNA OR
WALL ANTENNA OUTLET
REAR PANEL OF TV
RF CABLE
■ In the initial SET, exclusive channel for video is set to CH 3. To change this setting, set again in
CHANNEL SET screen in VCR operation.
■ In connecting RF cable to TV, set TV channel to CH3.
1. Remove circular cable (RF cable) (surplus cable) plugged in ANT.IN Jack in rear panel of TV. Connect the
cable to ANT.IN jack in rear panel of DVD-Video.
2. Connect TV to DVD-Video. Connect RF OUT jack in DVD-Video with ANT.IN jack in TV with RF cable.
INPUT 1
ANT IN
INPUT 2
REAR PANEL OF TV
AUDIO/VIDEO CABLE
REAR PANEL OF DVD-VIDEO
3. (If there is AUDIO/VIDEO INPUT jack in TV)
Connect VIDEO OUT jack in DVD-Video to VIDEO IN jack in TV, and AUDIO OUT jack in DVD-Video to
AUDIO IN jack in TV with connecting cable of Audio/Video jack.
Select VCR mode by pressing TV/INPUT button in TV, you can view more clear screen and sound than
connection with RF cable only.
VHF: 2 ~13 channels of TV
UHF: 14~69 channels of TV
CATV: Broadcasting is transmitted with cable from broadcasting station by contract with the station and
consumers. It does not need any antenna.
In/Out jack in Audio/Video terminal:
- In: A jack used to receive signal required in this unit from other units.
- Out: A jack used to send signal of this unit to other units.
Connect with Audio/Video terminal, you can enjoy more clear video and audio.
(Use OUTPUT button in this REMOTE to select video mode.)
CHECK UP! CHECK UP!