Planar E2C - Manual (Page 16)

6 | Dome E2c Display
Install the Display Controller
Before you install the display controller, make sure your display
system will be set up in a well-ventilated location with an adequate
amount of space. Excessive heat cannot dissipate when display vents
are blocked.
Turn off your computer and peripherals. Disconnect all the cables.
Leave the power cord plugged into the grounded outlet.
If you are installing multiple display controllers, install all boards
before you install the display driver.
To install the display controller
1 Remove the computer cover and then the blank bracket from
the available PCI Express slot.
2 Insert the display controller into the slot, align the connector pins,
and press the board down until it is firmly seated.
3 Secure the mounting bracket, and reattach the computer cover and
the peripherals.
Note
Diagnosis requiring DICOM calibration with the Dome CXtra
software can only be supported on the DVI-D interface.