Planar E2C - Manual (Page 25)

Connector Ports | 15
Connector Ports
The video signal connector is a standard DVI connector, driving data
to the display. Diagnosis requiring DICOM calibration with the
Dome CXtra software can only be supported on the DVI-D interface.
The Dome E2c display use an 8-pin DIN connector. The power input is
12V ±5% (120 W). See below for details of the DIN connector.
Input power port on connector plate
Assignments on 8-pin DIN connector
VCC 7
VCC 8
1 GND
VCC 5 3 GND
2 GND VCC 6
4 GND