Planar E2C - Manual (Page 17)

Installing the Display | 7
Connect the Video and Power Cables
Use only the power adapter (Ault MW122KA1223F52), power cord,
and the video cable shipped with the Dome E2c display.
To connect the cables
1 Plug one end of the DVI cable into the DVI port on the connector
plate. Secure the connection.
2 Plug the power cord into the power input port on the plate.
3 Plug the other end of the DVI cable into the video port on the
installed display controller. Secure the connection. (Use Video 1
port for the first display of a dual setup or for a single display.)
4 Plug the other end of the power cord into the power adapter, and
then connect the power adapter to a grounded AC outlet.
5 Repeat steps 1 to 4 to connect a second display to the controller.
6 Power on the display first, then the computer.
Controller
installed
DVI cable
DVI
port 1
DVI
port 2