Pioneer VSX-52TX - Manual (Page 71)

Additional information 12
71
En
Video
Can't record audio. • You are trying to make an analog recording
from a digital signal, or a digital recording of
an analog source. • You can only record analog to analog, or digital to
digital.
• The digital source is copy protected. • You can't record digital sources that have been copy
protected.
• The analog REC jacks have not been
connected properly.
• Check your analog connections (see Connecting analog
audio components on page 17).
Subwoofer output is very low. • The speaker settings result in very little
audio signal being sent to the subwoofer. • To route more audio signal to the subwoofer, set it to
PLUS , or select SMALL for the front speaker setting (see
Speaker Setting on page 44).
Everything seems to be set up
correctly, but the playback sound
is odd. • The speakers are out of phase. • Check that the positive/negative speaker terminals on
the receiver are matched with the corresponding
terminals on the speakers (see
Connecting the speakers
on page 20).
Noise or hum can be heard even
when there is no sound being
input. • There is electrical interference from another
component or appliance. • Check that personal computers or other digital
components connected to the same power source are not
causing interference.
There seems to be a time lag
between the speakers and the
output of the subwoofer. • The subwoofer channel can be delayed
slightly if run through a low-pass filter. • See Automatically setting up for surround sound
(MCACC) on page 11 to set up your system again using
MCACC (this will automatically compensate for a delay in
the subwoofer output).
The maximum volume available
(shown in the front panel display)
is lower than the
+12dB
maximum.
• The channel levels may have been adjusted. • This is not a malfunction. If the levels in Channel Level
on page 45 have been adjusted, the maximum volume will
change accordingly.
Symptom Cause Remedy
Symptom Cause Remedy
No image is output when an
input is selected. • The video connections are incorrect. • Make sure the video component is connected correctly
(see page 18).
• You are using component video
connections for your source, but not for your
TV. • Using the video converter, video signals can be
converted from a composite or S-video input to a
component video output, but not vice-versa. See
About the
video converter on page 15 for more on this.
• You are using component video
connections and the component video inputs
are assigned incorrectly. • Check Assigning the component video inputs on page 64
to make sure you’re assigned the correct input.
• The DVD/video player settings are incorrect. • Set correctly. Refer to the instruction manual supplied
with the DVD/video player.
• The video input selected on the TV monitor
is incorrect. • Set correctly. Refer to the instruction manual supplied
with the TV.
• Even though the sub room monitor is
connected properly, the multi-room feature is
switched off. • Press the MULTI ROOM&SOURCE ON/OFF button to
switch it on.
• The component video inputs are assigned
to a video component connected only to the
composite or S-Video terminals. • Check Assigning the component video inputs on page 64
to make sure the component video assign for that video
component is switched to
OFF .
• You connected your TV to the MULTI ROOM
& SOURCE MONITOR OUT jack instead of
the main MONITOR OUT jack.
• Connect the MONITOR OUT jack to the TV monitor (see
Connecting video components on page 18).
The System Setup screen
doesn't appear.
• Some TVs connected to the receiver with
component video cables do not display the
System Setup screen when the Color Burst
feature is on.
• When the receiver is in standby, switch to COLOR
BURST OFF by holding down the front panel ACOUSTIC
EQ button and pressing STANDBY/ON . (the current
setting appears in the display).
• The MONITOR OUT jack hasn't been
connected.
• You connected your TV to the
MULTI ROOM
& SOURCE MONITOR OUT jack instead of
the main MONITOR OUT jack.
• Connect the MONITOR OUT jack to the TV monitor (see
Connecting video components on page 18).
VSX_52TX.book.fm 71 ページ ２００４年５月１４日 金曜日 午前９時２１分