Pioneer VSX-52TX - Manual (Page 74)

Additional information 12
74
En
Resetting the main unit
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button, press and
hold the STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the display,
press ENTER.
OK?
shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
VSX_52TX.book.fm 74 ページ ２００４年５月１４日 金曜日 午前９時２１分