Peavey X-Four - Manual (Page 23)

p. 23
mono input module
rear panel features
direct out 1/4" TRS jack
The input channel's signal is available at this output jack.The
default signal routing is derived post-fader, post-eq and post-mute.This
output jack is ground-compensated.
insert points
Separate 1/4" TRS jacks provide the facilities for inserting an external sig-
nal processor into the signal path of the input channel.
insert send
This jack serves as an output for connection to the input of a
signal processor. The signal is derived after the mic preamp and HPF but
before the eq section.Plugging a 1/4" TRS plug into this jack does not break
the signal flow of the channel.This output jack is ground-compensated.
insert return
The output of a signal processor is fed to this jack. It can accept
a balanced or unbalanced signal and is located pre-eq.
balanced line-in jack—Bal Line In
Line-level signals, balanced or unbalanced, may be brought into
the input channel through this jack.The LINE switch must be depressed for
this jack to be active.
balanced mic-in xlr connector—Bal Mic In
This balanced female XLR accepts a low-impedance microphone
signal, or a line-level signal, depending on position of the LINE switch on
the front panel.
see—mono input module, phantom power, line
F
In situations where
the preamp circuitry is
not needed, the Insert
Return can be used as the
channel’s input.
For example, when using an
expensive tube mic preamp.
+
The insert send can
also be used as an
additional channel output
when s pre-EQ signal is
needed.
+
1