Planar Dome E4c - Manual (Page 11)

About the Display | 3
Display power
The power input port is an 8-pin DIN connector that drives power to
the display. See
page 17 for the pin assignment.
The dual-link DVI cable drives data to the display and is integrated
into the display unit. When the DVI cable is disconnected from the
graphics board, the display backlight turns off and the unit enters
power-saving mode.
Display brightness and power saving functions are controlled via the
Dome CXtra software. No other user-accessible controls are available.
DIN connector, left
Integrated dual-link DVI cable, right
mx4.book Page 3 Wednesday, August 9, 2006 3:03 PM