Planar Dome E4c - Manual (Page 15)

Display Installation | 7
To install the graphics board and display
1 Remove the computer cover and the blank bracket from
the available PCI slot.
2 Insert the graphics board into the slot, align the connector pins,
and press the board down until it is firmly seated. Secure the
mounting bracket and reattach the cover.
3 Plug the DC power cord into the power input port on the display.
Connect the dual-link DVI cable to the display.
4 Connect the DVI cable to the bottom port of the graphics board
installed in the computer. Plug the AC power cord into the power
adapter and into the grounded power outlet.
See page 6 for illustration of the install procedure.
Installation tip
Both DVI ports function on the graphics board shipped with your
Dome E4c display, but only the bottom port allows you to enable
dual-link functionality. Use the bottom port to support the display
with the full, non-scaled 2560 x 1600 resolution.
DVI port for dual-
link functionality
MX4 display controller
mx4.book Page 7 Wednesday, August 9, 2006 3:03 PM