Planar Dome E4c - Manual (Page 6)

vi | Dome E4c Display
Shipping/storing the display
Keep the display in its shipping container until installation. Return the
display to its original container whenever you need to store the unit,
move it to another location, or return it for repair.
Safety tips
• Use caution when adjusting the position of the display. Improper
handling of the unit may result in hand injury. Always grasp the
sides of the display to adjust the viewing angle, height, or tilt.
• Never place your hands between the display and the stand base
when lowering the display height.
• Never open the display case, even when the power is off. Do not
drop or push objects into the display case. Dangerous voltage
inside may cause electric shock or death.
• Use the grounded power supply and the video cable supplied by
Planar. Replace the power supply or video cable if damaged.
• Be sure the display is electrically grounded. Connect the third
grounding pin on the US power cord to a grounded outlet. The
European power cord lacks a third grounding pin, but it must be
plugged into a grounded outlet. If the power cord connects
directly into the computer, make sure the computer is grounded.
• Keep the display dry if it is part of a surgical system. The display
lacks protection against liquids or spills.
• Do not plug the power supply into an overloaded AC outlet or
extension cord. Overloaded AC outlets and cords can result in
electric shock or fire.
• Unplug the power cord from the wall outlet during
thunderstorms.
• Do not place magnetic devices, such as motors, near the display.
• In locations where 240V outlets are used, connect the
Dome E4c display to a center-tapped, 240V, single-phase
supply only (for Canada and the United States only).
mx4.book Page vi Wednesday, August 9, 2006 3:03 PM