Planet Technology SGSW-2402 - Manual (Page 16)

12
3.5 Trunk config
Port Trunking is the ability to group together several switch ports to increase the bandwidth between the
management switch and other switch. This is an inexpensive method to increase throughput between
switches (or to servers). We define the Port Trunking as the ability to group a set of ports into a single
logical link. The port trunk acts as single link between switches. It doesn’t create a loop even though it is
physically connected as such.
Figure 3-5 The Port Trunk config Page
Port Trunking Setup Procedures
Step 1: You can choose up to 4-port for Trunking by selecting ‘-‘ as “T”
Step 2: Click on “Apply” button to make the configuration effective.
Step 3: Click “Save” button to save the latest setting.
NOTE
If you select more than 4 ports for trunking, the following error message will appear:
Click “OK” button and select the ports again