Pioneer VSX-41 - Manual (Page 12)

5 minute guide 02
12
En
Using the Quick Setup
You can use the Quick Setup to get your system
up and running with just a few button presses.
The receiver automatically makes the necessary
settings after you have selected your speaker
setup and room size. If you want to make more
specific settings, refer to Choosing your receiver
setup on pages 36–42 Use the front panel
controls for the steps below.
DOWN UP
ENTER
INPUT
SELECTOR
MASTER VOLUME
MULTI JOG
AUDIO/VIDEO MULTI-CHANNEL RECEIVER N∫m- ¯,
SPEAKERS
S-VIDEO VIDEO L AUDIO R
ADVANCED
SURROUND STEREO/
DIRECT
SIGNAL
SELECT MIDNIGHT/
LOUDNESS MONITOR TONE QUICK SETUP
VIDEO INPUT
LISTENING MODE
FL DIMMER
MULTI JOG
DIGITAL IN
1 If the receiver is off, press STANDBY/
ON to turn the power on.
The
STANDBY indicator goes out.
2 Press QUICK SETUP.
The display prompts you to select your speaker
setup.
3 Use the MULTI JOG/INPUT SELECTOR
dial to choose your speaker setup.
Cycle between the following choices:
7.1ch 4.1ch
7.0ch 5.0ch
6.0ch 6.1ch 5.1ch
3.1ch 3.0ch 4.0ch
Check the table below to find the speaker
setup that corresponds with your system.
4 Press ENTER.
The display prompts you to select your room
size.
5 Use the MULTI JOG/INPUT
SELECTOR dial to choose your room size.
Depending on the distance of your speakers
from the listening position, choose between
Small, Medium, or Large (see table below).
S
12 ft.
10 ft.
6 ft.
3 ft.
Front
Center
Surround
Surround Back
M
12 ft.
10 ft.
7 ft.
5 ft.
L
12 ft.
10 ft.
9 ft.
7 ft.
6 Press ENTER to confirm your setup.
The display shows the speaker setup and room
size that you have selected.