Pioneer VSX-41 - Manual (Page 50)

09
50
En
Controlling the rest of your system
Clearing all the remote
control settings
You can clear all presets and restore the factory
default settings.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press any MULTI CONTROL button.
3 Use
} and ] to select RESET then
press REMOTE SETUP.
The LCD display shows OK.
Erasing one of the remote
control button settings
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button
relating to the button setting to be
erased.
3 Prepare the remote to erase the button
setting.
Use
} and ] to select ERASE and
then press REMOTE SETUP.
The LCD display flashes PRES KEY.
4 Press and hold the button to be erased
for three seconds.
The LCD display shows OK to confirm the
button has been erased or NO CODE if an
error has occurred.
5 Repeat step 4 to erase other buttons.
6 Press and hold the REMOTE SETUP
button for two seconds to exit.
The LCD display will show OK if the
operation has been learned.
If for some reasons the operation hasn’t
been learned the LCD will display
ERROR for
three seconds and then display PRES KEY
again. If this happens, keep pressing the
(teaching) button as you vary the distance
between the two remotes, until the LCD
display shows
OK.
To program additional operations for the
current component repeat steps 4 and 5.
To program operations for another compo-
nent exit and repeat steps 1 through 5.
6 Press and hold the REMOTE SETUP
button for three seconds to store the
operation(s).
• Some commands from other remote controls
cannot be learned, but in most cases the
remotes just need to be moved closer together
or farther apart.
• Certain buttons represent operations that
cannot be learned from other remote controls.
These include: MULTI CONTROL, RECEIVER ,
REMOTE SETUP, RECEIVER CONTROL and
MASTER VOLUME.
• TV CONTROL buttons (TV , TV VOL +/-, and
TV INPUT) can only be learned after selecting
TV or TVC.