Panasonic BT-H1700BP - Manual (Page 9)

9
Ⅵ INSTALLING THE INPUT CARD
Optional input cards are necessary to use the functions of this
monitor. Before mounting the monitor or connecting other
equipment to the monitor, be sure to install the input cards.
1. Turn off the Multi-Format Monitor’s main power
and unplug the power cable from the AC outlet.
2. Unscrew the screws and remove the slot cover
from the slot (on the rear side of the monitor) in
which you are going to install the card.
3. Insert the Input Card’s board (green-colored)
into the slot, fitting the board into the guide rails
on the top and bottom of the slot.
4. Push the Input Card in so that its front panel
touches the monitor’s rear panel.
5. Secure the Input Card by replacing the screws
removed in Procedure 2.
NOTES:
• Do not touch the terminal connected to the monitor or board pattern.
• Do not remove slot covers from the monitor’s slots if they are
not in use.
Ⅵ ATTACHING THE WIDE MASK
A wide mask is provided with the monitor. This changes the
viewable screen area to the 16:9 aspect ratio.
• The wide mask cannot be attached to the monitor after the
monitor is mounted in a rack. Mount the wide mask before
installing the monitor in a rack.
1. Prepare the provided wide mask and 4 screws
(for attaching).
2. Attach the wide mask to the monitor.
3. Secure the wide mask with the screws (fix 2
screws each to both right and left side).
• When detaching the wide mask, follow this procedure in
reverse.
Caution:
Use only the provided screws.
Slot cover
Knob
Guide rails
Knob
Input card (the illustration
shown is of the BT-YA701P)
Rear side of the BT-H1700B
Multi-Format Monitor
PREPARATION
Fit the board to
the guide rails.
LCT1464-001A_EN_02-09-6 03.9.19, 14:45 9