Peavey X-Monitor - Manual (Page 25)

Output features
Output Control
Talk to
The Talk back signal is assigned to the group.The level of the Talk back signal is con-
trolled by the Talk Back level control in the Master section.
Polarity reverse
The polarity of the Group output is reversed.
Stereo Pair
This switch with accompanying LED globally sets the configuration of the input
Mix pots associated with each pair of outputs. For each odd/even pair, the Mix send pots
are configured as Level / Pan.The odd numbered control sets the level, and the even num-
bered control adjusts the stereo placement (pan).
Safe preview
Safe Preview LED
See LOCAL MICROPROCESSOR CONTROL section
Mute
Mute switch
See LOCAL MICROPROCESSOR CONTROL section
PK / SIG
The Peak / Signal level LED indicates the output level. It illuminates green, varying in
intensity with the level of the audio signal. Red (Peak) indicates peaks and distortion. Peak
is sensed both before and after the fader, while signal level is sensed before the fader only.
Bus assignments 13, 14, 15 & 16
The Group signal is assigned to Buses 13-16 which feed Matrix 1 - 4, located above
the master control section.The feed to Buses 13-16 is normally Post-fader.All Bus 13-16
sends (from Inputs and Groups) can be globally switched to Pre-fader by using the 13-16
PRE switch, located in the Master section.
Bus A assignment
The Group signal is assigned to the main A output bus.This feed is always Post-fader.
Bus B assignment
The Group signal is assigned to the main B output bus.This feed is always Post-fader.
Group fader
The 100mm fader controls the level of the Group output and any Post-fader send.
Solo switch
Pressing this momentary switch will include (illuminate) or exclude (not-illuminated)
the group from the consoles solo system. See Master Control Section for information on
Solo options.
L E D
L E D
L E D
p. 25
Output groups 2