Peavey X-Monitor - Manual (Page 33)

Matrix Mix features
The Matrix section is fed from the internal Bus 13 thru 16 signals.These internal buses get
their signal from the Input and Groups via the Bus 13-16 assignment switches.The assign-
ment to Buses 13-16 is normally post-fader, a master switch globally changes this to pre-
fader. Each Matrix also has its own External input which can be mixed in with the Bus 13-
16 signals.The External Input signal comes from the four 1/4” TRS jacks located on the rear
of the Master Module.
13- Bus 13 mix level into the Matrix.
14- Bus 14 mix level into the Matrix.
15- Bus 15 mix level into the Matrix.
16- Bus 16 mix level into the Matrix.
EXT IN- External Input mix level into the Matrix, from TRS jack on rear panel
MUTE- Micro-controllable mute control. See Micro-instructions for operation.
LEV- Master Level control for Matrix output.
SOLO- Allows monitoring of the Matrix signal in the Solo system.This feed follows
the master SOLO MODE switch. Pre-fader monitors the actual Matrix mix-bus, Post-Fader
monitors the Matrix signal after the Master Level and Mute controls. In the X-Monitor, the
Solo system makes a distinction between Inputs and Outputs.The Matrix Solo is treated as
an Output by the Solo system. See the Solo Section of the manual for details on the differ-
ent Solo functions and modes.
p. 33
Master section 3